Choose a country or area to see content specific to your location
應用說明
The Keysight i7090 can measure up to 60V on a device under test (DUT) board; most of the time, these DUT boards only require less than 25V. However, depending on the circumstances, some boards might require as high as 48V. It is important to discharge the voltage on the DUT after powering off to protect the pin cad from damage caused by the excessive power residue.
Due to the i7090 can only directly discharge up to 25V, we have devised a solution that involves lowering the voltages of the DUT boards that need higher voltages to 25V before letting the i7090 safely discharge the DUT.
解鎖內容
免費註冊
*Indicates required field
感謝您!
您的表格已成功送出
如果瀏覽器 cookie 已過期或快閃記憶體內容被清除,請您重新刷新網頁。 如欲重新存取內容,請再次登入。。
×
請銷售人員與我聯絡。
*Indicates required field
感謝您!
A sales representative will contact you soon.