E4980A LCR Meter
傳單
Procedure overview
- Preset system
- Perform compensation of fixture
- Set measurement parameters
- Connect DUT and measure at a single frequency
- Set up list sweep table
- Set trigger mode and make sweep measurement
In this demo...
- Measurement of chip SMD device
- Fixture compensation
- List sweep
1. Preset system
a. Press [Preset] front panel key
b. Press CLEAR SET&CORR softkey
c. Press OK softkey (wait about 20 seconds…)
2. Perform compensation of fixture
a. Set fixture to UNKNOWN terminals
b. Press [Meas Setup] front panel key
c. Select CORRECTION softkey
d. Move cursor onto OPEN field by pressing
[▼] front panel key
e. Make open condition for the test fixture