Choose a country or area to see content specific to your location
Confirm your country to access relevant pricing, special offers, events, and contact information.
PRODUCTS AND SERVICES
- Spectrum Analyzers (Signal Analyzers)
- Network Analyzers
- Logic Analyzers
- Protocol Analyzers and Exercisers
- Bit Error Ratio Testers
- Noise Figure Analyzers and Noise Sources
- High-Speed Digitizers and Multichannel DAQ Solutions
- AC Power Analyzers
- DC Power Analyzers
- Materials Test Equipment
- Device Current Waveform Analyzers
- Parameter / Device Analyzers and Curve Tracers
- Generators, Sources, and Power Supplies
- Modular Instruments
- Network Test and Security
- Network Visibility
- KeysightCare Service and Support
- KeysightAccess Service
- Calibration Services | Global Calibration Services
- Repair Services
- Technology Refresh Services
- Test as a Service — TaaS
- Network / Security Services
- Consulting Services
- Financial Services
- Education Services
- Keysight Support Portal
- Used Equipment
- All Services
- Additional Products
- All Products, Software, Services
Data Center Infrastructure Management (DCIM)
DCIM solutions provide an overall view of a data center's performance through the integration and analysis of IT and building facility systems.
Data center infrastructure management addresses the top three concerns of data center operators and managers: cost, footprint, and power.
Slide 3 / 12
Gigabit Ethernet (GE)
The Institute of Electrical and Electronics Engineers (IEEE) 802.3 standard defines gigabit Ethernet as the transmission of Ethernet frames at a rate of 1 billion bits per second (Gb/s).
Data center operators need to evolve the speed of their networks from 100GE to 400GE to support the response times and high bandwidth requirements of emerging technologies such as 5G and IoT.
Slide 4 / 12
Forward Error Correction (FEC)
An advanced coding technique used to control and mitigate errors in data transmission over unreliable or noisy communication channels. PAM4 signaling will use FEC encoding to account for its lower signal-to-noise ratio. The required information to correct errors passes through the link along with the payload data.
Slide 6 / 12
Peripheral Component Interconnect Express (PCIe®)
PCIe is a computer expansion bus standard that enables faster data exchange between a computer processor and peripheral devices. Technologies such as 400GE drive I/O interconnect technologies, including PCI Express, to 32 gigatransfers per second (GT/s).
Slide 7 / 12
Quadrature Amplitude Modulation (QAM)
QAM is a two-dimensional modulation format that modulates both the phase and amplitude of light to transmit a signal through a fiber optic cable. Higher order QAM signaling enables significantly faster data transmission rates and higher levels of spectral efficiency.
Metro networks and data center interconnects will use QAM signaling to provide significantly faster data transmission rates.
Slide 11 / 12