How to Measure Photodiode Dark Current

+ Femto / Picoammeters and Electrometers

Measure Reverse-Bias Dark Current

The test requires a photodiode mounted in an enclosed fixture so that no light reaches the device during measurement. A reverse-bias voltage is applied to the photodiode cathode while the resulting current is measured at the ammeter input. The measurement setup must support a voltage sweep and current acquisition over the expected low-current range.

For a representative silicon photodiode test, sweep the reverse-bias voltage from 10 mV to 5 V using 500 points and a fixed 20 pA current range. Use a 1 s measurement delay and a 1.2 s measurement period so that leakage and dielectric-absorption transients can settle before each reading. Display the current-voltage result on a logarithmic X-Y graph for quick examination.

Photodiode Dark Current Measurement Solution

The test requires a reverse-bias voltage sweep while the photodiode current is measured synchronously. The Keysight Electrometer / High Resistance Meter combines the voltage source and ammeter in one instrument, allowing the reverse-bias voltage to be swept while current is acquired at each point. For the example setup, the measurement uses a fixed 20 pA range, 500 sweep points from 10 mV to 5 V, and a 1 s measurement delay with a 1.2 s period. The instrument provides Graph View with logarithmic X- and Y-axis scaling for examining the current-voltage curve, and the measurement can be initiated from the front panel or remotely using SCPI commands.

Get Quote

See Block Diagram of Photodiode Dark Current Measurement Solution

Explore Products in Our Photodiode Dark Current Measurement Solution

B2985C Electrometer / High Resistance Meter, 0.01 fA

Learn More View Data Sheet
B2987C Electrometer / High Resistance Meter, 0.01 fA, Battery

Learn More View Data Sheet