How to Generate mmWave Signals With Frequency Extenders

Get Quote
Pro Analog Signal Generator
+ Pro Analog Signal Generator
Pro Analog Signal Generator
+ Pro Analog Signal Generator

Extend Microwave Signals Into mmWave Bands

Generating millimeter-wave signals with a frequency extender requires a microwave signal source, a compatible multiplier module, and the appropriate waveguide connection for the target band. The microwave source provides the input signal to the extender, where frequency multiplication produces a higher-frequency output. Engineers set the input frequency and power based on the extender’s multiplication factor and operating requirements.

A typical setup routes the source into the extender’s RF input and the multiplied output through waveguide to the device or measurement path. Engineers select the source frequency and power to achieve the required mmWave output, then sweep the output across the supported band while maintaining the required stimulus conditions. The resulting signal can be applied to a DUT or monitored with compatible mmWave instrumentation.

mmWave Frequency-Extender Signal Generation Solution

Generating a millimeter-wave stimulus requires driving a compatible frequency extender with the microwave frequency and power needed by its multiplier chain. The solution combines a microwave signal generator with frequency-extension hardware that translates the source signal into a higher-frequency waveguide output. Engineers configure the microwave input according to the extender multiplication factor and desired output frequency, then route the resulting signal to the device or measurement system through the appropriate waveguide interface. This arrangement extends microwave signal generation into mmWave testing bands without requiring the base signal source to produce the final frequency directly. Frequency control remains tied to the microwave source while the millimeter-wave frequency extender performs the required multiplication. The configuration supports frequency sweeps and controlled high-frequency stimulus generation for component and system measurements across the extender's supported operating band.
Get Quote

See Block Diagram of mmWave Frequency-Extender Signal Generation Solution

Block Diagram of mmWave Frequency-Extender Signal Generation Solution

Explore Products in Our mmWave Frequency-Extender Signal Generation Solution

Related Use Cases

How to Characterize 6G Sub-THz Wideband Signals

Engineers researching 6G H-band implementations require a wideband modulated signal generator with a high carrier frequency signal to evaluate 6G RF waveform performance. Learn how to characterize sub-THz wideband signals in the H-band using a 6G research testbed with custom modulation signal generation software.

Learn More

How to Test 6G Receivers With Low-Noise Signals

Test 6G receiver performance using a spectrally pure, low-noise microwave stimulus. Configure the signal source, establish the required carrier frequency and power, and control source phase noise and spectral purity so unwanted signal-generator impairments do not dominate receiver measurements.

Learn More

How to Measure the Energy Efficiency of an O-RU

Measuring the energy efficiency of an O-RAN radio unit (O-RU) requires an O-RAN distribution unit (O-DU) emulator, a DC power supply, and an RF power sensor. Learn how to measure energy efficiency following ETSI standards.

Learn More

contact us logo

Get in Touch with One of Our Experts

Need help finding the right solution for you?

Contact Us