RPA Walkthrough Video 01

This video guide walks through the basics of PathWave Instrument RPA for single Connection.

Software Experience Demo: 5G IoT Security Solutions

Learn how to assess the security of a device connected to a 5G cellular network using Keysight’s IoT Security Assessment Solution and the UXM 5G network emulator.

Testing 200 Gbps Lanes with Keysight Technologies at OFC 2021

Research is underway to develop the technology required for 200 Gbps lanes. At OFC 2021, Keysight demonstrates accurate waveform tests for next-generation transmitters using an N1000A DCA-X, N1030A optical reference receiver, and a UXR-Series oscilloscope with an N7005A external O/E converter. This test system will be used to characterize signals generated by a 212 Gbps E/O driven by a M8199A AWG.

RSE Use Case: Extended Object Demo

Video explaining how the current ways of testing automotive radar’s extended object tracking capability, are incomplete and therefore potentially risky, and a demonstration of how the RSE addresses that.

M8199B Waveform Generator

Steve Reinhold demonstrates the capabilities of Keysight's M8199B arbitrary waveform generator with a DCA-X oscilloscope.

Cross Platform Automation with RPA

Keysight PathWave Instrument RPA enables seamless connectivity to interact and orchestrate automation across multiple instruments, devices under test (DUT), and applications without needing to write test automation scripts. Hardware debugging and characterization can take up a lot of time due to repetitive tasks on mouse clicks and manual keyboard entries. In this demo video, RPA automates command line instructions on Linux OS to drive frequency changes and measures the resulting amplitude and frequency on an Oscilloscope. RPA then transfers the data to an external application for Machine Learning.

How to Make Channel Power Measurement

Demonstration of how X-Series Signal Analyzer can be used to measure RF Power

Introducing the VXG Microwave Signal Generators

VXG Microwave Signal Generator Introduction Video

6G R&D Testbed for 220-330 GHz with 30 GHz Bandwidth

6G R&D Testbed over-the-air (OTA) demo at 310 GHz with 30 GHz of bandwidth to achieve 100 Gbps data throughput.

ADS Layout Look-A-Like Components

Demonstration of ADS can use look-a-like component in the schematic

Physical Layer Validation Challenges of Characterizing 100/200 Gbps/lane Designs

This session will be a practical discussion of IEEE 802.3ck (100Gbps/lane) physical layer conformal testing for both Tx and Rx. 100G silicon is emerging from the early specifications and a world of simulation. This track will help bridge the gap between simulation and physical layer evaluation of SERDES design and conformance testing.

Measure Phase and Amplitude Noise to mmWave Frequency

Demonstration of N5511A Phase Noise Test System

100G Electrical TX and RX Conformance Test Solution

Keysight’s new pre-conformance 100GAUI-1 compliance test solution simplifies the testing of 100Gbps electrical interfaces by automating over 120 transmitter measurements (Tx) and receiver test procedures (Rx) for chip-to-module (C2M) and chip-to-chip (C2C) interfaces. The move to 100Gb/s and 53Gbaud PAM4 enables new technology such as 800G optical transceivers, as well as 51.2 terabit switches. This optimizes bandwidth and switching capacity, whilst reducing the cost and power consumption for the user.

Software Experience Demo: Automate gNB Conformance

This video outlines 3GPP and O-RAN conformance testing and key challenges. It includes a demonstration of Keysight’s P7000A Base Station Measurement Automation Solution performing a series of Chapter 6 and Chapter 7 conformance tests on an open radio unit tested in isolation.

Seamless Low-Frequency Noise Stress Test with A-LFNA

This video demonstrates how A-LFNA can be executed the stress test. The low-frequency noise is one of the indicators of the reliability of the semiconductor devices, and A-LFNA provides the seamless stress test.

Simplify Measurements with Integrated Features | Keysight X-Series Signal Analyzer

Setting Up Noise Figure Measurement

Demonstration of how to measure Noise Figure for a simple converter

Keysight U/L2050/60 X-Series USB/LAN Power Sensors Demo

Keysight U/L2050/60 X-Series USB/LAN Power Sensors Demo

ADS Pathfinding Next Generation Memory Systems

In this video, we demonstrate how we support and help leading-edge technology development by unlocking pathfinding mode for next generation memory systems. Are you working on pre-DDR6, LPDDR6, GDDR7, HBM4, or beyond? Newly introduced multi-level modulation and a new CA-to-CA ratio require simulator support not found in other EDA tools.

How to Test the Energy Efficiency of an O-RU

Demo video of measuring energy efficiency of O-RAN.