Column Control DTX
Column Control DTX

How to Characterize Embedded Serial Buses

Mixed Signal Oscilloscope
+ Mixed Signal Oscilloscope

Analyzing embedded serial buses with an oscilloscope

Analyzing serial buses in embedded designs requires using an oscilloscope with serial protocol analysis and either deeper memory or segmented memory acquisition. This helps ensure that you can capture analog and digital waveforms over a longer time span and that you can capture more packets. An oscilloscope with segmented memory acquisition enables you to digitize only the important portions of the waveform under test at a high sample rate.

During this test, the segmented acquisition mode on the oscilloscope is turned on. This allows the oscilloscope to ignore unimportant idle time between packets and instead, optimize the number of serial packets captured consecutively or select packets with just a particular ID or address. You can then scroll through the frames to identify any anomalies. Use time-tagging to make latency timing measurements between the frames. Additionally, a time-interleaved lister can display two serial buses and correlate data transfers with other mixed-signal interactions in your system.

Column Control DTX
Embedded serial bus characterization solution

Serial bus characterization solution

Characterizing embedded serial buses requires debugging buses and correlating data transfers with other mixed-signal interactions. The Keysight InfiniiVision 3000G X-series oscilloscope with analysis software and probes analyzes the most common serial buses, including  I2C, SPI, UART, and others. The solution supports protocol analysis using segmented memory acquisition.
Column Control DTX

See demo of serial bus characterization

Column Control DTX

Explore products for our serial bus characterization solution

Column Control DTX
Column Control DTX

Related use cases

Column Control DTX
contact us logo

Get in touch with one of our experts

Need help finding the right solution for you?