Choose a country or area to see content specific to your location
Enable browser cookies for improved site capabilities and performance.
Toggle Menu
-
Products + Services
-
Oscilloscopes + Analyzers
- Oscilloscopes
- Spectrum Analyzers (Signal Analyzers)
- Network Analyzers
- Logic Analyzers
- Protocol Analyzers and Exercisers
- Bit Error Ratio Testers
- Noise Figure Analyzers and Noise Sources
- High-Speed Digitizers and Multichannel DAQ Solutions
- AC Power Analyzers
- DC Power Analyzers
- Materials Test Equipment
- Device Current Waveform Analyzers
- Parameter and Device Analyzers, Curve Tracers
-
Meters
-
Generators, Sources + Power
-
Software
-
Wireless
-
Modular Instruments
-
Network Test
-
Network Security + Visibility
-
Additional Products
-
Services
- All Products, Software, Services
-
-
Solutions
- Industries
- Insights
- Resources
- Support
No product matches found - System Exception
- Home
- Resources
- Resources
FieldFox Series Firmware Updates
If you have not downloaded firmware before, please read the various notes below. If you are familiar with downloading firmware files, then just use the links below. Please save the file to disk before attempting to install it! New firmware releases typically occur in 3-6 month intervals. The dates shown for each firmware revision are the compile dates; not the actual release dates, which may be much later.
Currently Available FieldFox Firmware |
||
FieldFox Model Numbers | Latest Releases | Notes |
|
A.12.46 All FieldFox models (6 June 2022) |
For analyzers with CPU2. Check CPU by pressing: [System] {Service Diagnostics} {System Information} Bios Rev will state CPU2, or CPU=2 |
|
A.08.19 |
N991xA/N992xA/N993xA firmware update instructions (to/within A.07.xx or A.08.xx) For analyzers with an older CPU. Check CPU by pressing: [System] {Service Diagnostics} {System Information}. Bios Rev will say 2.4x (no mention of CPU) |