How to Characterize Embedded Serial Buses
Analyzing embedded serial buses with an oscilloscope
Analyzing serial buses in embedded designs requires using an oscilloscope with serial protocol analysis and either deeper memory or segmented memory acquisition. This helps ensure that you can capture analog and digital waveforms over a longer time span and that you can capture more packets. An oscilloscope with segmented memory acquisition enables you to digitize only the important portions of the waveform under test at a high sample rate.
During this test, the segmented acquisition mode on the oscilloscope is turned on. This allows the oscilloscope to ignore unimportant idle time between packets and instead, optimize the number of serial packets captured consecutively or select packets with just a particular ID or address. You can then scroll through the frames to identify any anomalies. Use time-tagging to make latency timing measurements between the frames. Additionally, a time-interleaved lister can display two serial buses and correlate data transfers with other mixed-signal interactions in your system.
Serial bus characterization solution
See demo of serial bus characterization
Explore products for our serial bus characterization solution
-
![]()
N2756A MSO Cable Kit, 16-Channel
-
![]()
N2843A Passive Probe, 10:1, 500 MHz, 1.2 m
-
![]()
MSOX3054G Mixed Signal Oscilloscope: 500 MHz, 4 Analog Plus 16 Digital Channels
-
![]()
D3000GENB Embedded Analysis Software for the 3000A/T/G X-Series
Discover resources and insights
Additional resources for embedded serial bus characterization
Related use cases
-
![]()
Learn More
How to Validate DC Power Rail Stability During Load Changes
Validate DC power rail stability during load changes using the Keysight Expert benchtop oscilloscope with power integrity analysis software and power rail probes.
Learn more
-
![]()
Learn More
How to Characterize Frequency Response in Power Supply Feedback Loops
Characterizing gain and phase response in power supply feedback loops requires an Advanced Benchtop Oscilloscope. Learn how to characterize using built-in frequency response analysis (FRA) and software for control loop response measurements.
Learn more
-
![]()
Learn More
How to Measure Switching Transistor Power and Energy Loss
Measuring switching transistor power and energy loss requires an Advanced benchtop oscilloscope with power measurement software, high-voltage differential probes, current probes, and probe deskew for accurate switching-loss analysis.
Learn more
Get in touch with one of our experts
Need help finding the right solution for you?