The Keysight 8.2.5 patch can only by installed on 5DX systems running software release 8.2.3. The 8.2.5 patch is a cumulative patch and also contains the fixes in 8.2.4.

Preparing the 5DX System for Installation of the Self-Extracting 8.2.5

  1. Stop inspections and unload all panels from the system.
  2. From the User Interface, perform a long-term shutdown by selecting System Access > Shutdown > Long-Term Shutdown.
  3. Exit out of the User Interface.
  4. Double-click the Keysight 5DX Reset icon to reset the system.
  5. Check that your 5DX or TDW software license file is named "software.lic". If it is not named "software.lic", please change the name. This will not affect the system operation but will allow the patch to install properly. The file is located c:\5DX\R82\config\license.
  6. Close all other programs; close any open windows.

Installation of the Self-Extracting 8.2.5 Patch

  1. Download the file Keysight 5DX Self-Extracting 8.2.5 Patch to a local drive.
  2. From Windows Explorer, run the Self-Extracting 8.2.5 patch.
  3. Click Next in the Welcome screen to install the patch.
  4. Click Install in the Start Install window.
  5. Click Finish at the Install Shield Wizard Complete screen. You will not be required to reboot the system. The installation of 8.2.5 is now complete.

Restarting the 5DX System

  1. Double-click the Keysight 5DX Reset icon to reset the system.
  2. Double-click the Start 5DX Interface icon to bring up the User Interface.
  3. Perform a startup by selecting System Access > Startup > Automatic Startup.

Verifying Proper Patch Installation on the 5DX

You may verify that the patch has been properly installed by checking the system version number at the top of the 5DX user interface. The number should reflect 8.2.5 after the installation of the patch.