Supported on all N522xB/N524xB PNA/PNA-X test set based millimeter-wave solutions
Supports broadband N5290A/91A with either 2- or 4-port configurations
Supports banded waveguide frequencies to 110 GHz
Utilize the Cal All feature on the PNA/PNA-X for calibrated spectrum analysis measurements
DANL of 120 dB/Hz (typical)
Multichannel spectrum analysis at millimeter-wave frequencies
Either N5261A/62A or N5292A millimeter-wave controller is required
The S93093A has all of the capability of the S93090xA spectrum analyzer application, with an upper frequency of 110 GHz. It is intended for analyzers configured with broadband or banded millimeter-wave frequency extenders, using a millimeter-wave controller. With this configuration, the analyzer’s internal receiver attenuators are not in the receiver paths, so they cannot be used to reduce signal levels. External attenuators may be required to avoid compressing the receivers in the millimeter-wave frequency extenders. When using the S93093A for millimeter-wave spectrum analysis, either N5261A/62A or N5292A millimeter-wave controller is required. When the S93093A is installed on a standalone network analyzer, it will provide spectrum analysis up to the frequency limit of the instrument.