Here's the page we think you wanted. See search results instead:

Unleash your highest-performing data center infrastructure for AI/ML applications. Let Keysight enable you to push the boundaries of engineering by solving complex design, emulation, and test challenges to create and deliver the best AI infrastructure and experiences to your customers.

DATE / LOCATION

March 26 - 28, 2024
San Diego Convention Center
111 W Harbor Drive
San Diego, CA
Booth 3701

Register for OFC

Enable Data Center Infrastructure for Next-Generation AI

AI and ML drive architectural optimization of data center infrastructure to minimize energy consumption and latency and increase scalability at the same time.

Keysight is leading the way with cutting-edge test and measurement solutions designed to ensure that your devices and systems are AI-ready.

Showcase Demos

PCIe 7.0 over optics

Keysight presents a low-power PCIe 7.0 optical interconnect technology supporting emerging large language model needs for higher efficiency signaling. Featured products include N1092A, the optical channel DCA-M, N7736C, an optical switch, and the Eoptolink 800G DR8 linear pluggable optics (LPOs).

Linear drive optics

Linear drive optical transceivers exhibit lower latency, power consumption, and cost than traditional re-timed transceivers making then an ideal solution for AI applications. This demo showcases Keysight’s validation solutions for the CEI-112G-Linear-PAM4 standard on linear pluggable optics, including new measurements such as EECQ (Electrical Eye Closure Quaternary) and new reference receiver equalization techniques.

224G Tx validation

This demo illustrates the performance of 224G Tx validation using a 224G PHY from Marvell and illustrates jitter, and Partial Response Maximum Likelihood Sequence Estimation (PR-MLSE) equalization.

Keysight at OIF and Ethernet Alliance Booths

OIF #1323

We are showcasing interoperability solutions highlighting 800ZR, 400ZR, and OpenZR+ optics.

  • Keysight's AresONE 800GE-M Dual Interface Model 4-Port Test System will be shown in the X00ZR coherent optics interoperability demo, supporting both 800ZR optics, OSFP and QSFP-DD connections.
  • The AresONE 800GE-M Dual Interface Test System will be used to send and receive 1x800GE line-rate Layer 2 packet traffic to a Juniper 800G router, via 800ZR optic connections on both sides.
  • CEI-224G-LR at OFC 2024: This is the first OIF-CEI multivendor long reach interoperability demonstration, with test silicon sending 212 Gbps signals over cabled backplane Long Reach (LR) channels and 40 dB of insertion loss die to die at 56 GHz. This is a key building block for enabling system-to-system interoperability, driving the 1.6T data center connectivity requirements.
  • CEI-112G-Linear at OFC 2024: This demonstration encompasses a comprehensive Low Power ecosystem enabling multi-vendor CEI-Linear interoperability. Showcase multi-vendor SerDes represented by test platforms emulating Ethernet devices such as a switch and a test and measurement device driving single mode and multi-mode, multivendor Linear Pluggable Optics (LPO) while demonstrating quality BER with FEC tail margin, at minimal power consumption. The demo showcases the interoperability between LPOs interfacing with retimed modules and compatibility between the two pluggable options.

Ethernet Alliance Booth #1415

We are showcasing a variety of demos, and a diversity of interconnects, including speeds from 10Gbps to 800Gbps.

  • AresONE 800GE-8P-QSFP-DD800-M Layer 1-3 Test System will be featured in the 400G/800G Switch Fabric demo.  Connections to major switch vendors (Juniper, Cisco, and Arista) will be shown, using a wide range of speed configurations and interconnects, including DACs (Direct Attached Cable), 400ZR/ZR+ coherent optics, and 800G short reach optics.
  • AresONE 800GE-8P-QSFP-DD800-M Layer 1-3 Test System will also be featured in the Auto Negotiation/Link Training (AN/LT) interoperability demo.
  • AresONE 800GE-8p-OSFP800-M Layer 1-3 Test System will be featured in the Linear Drive Pluggable Optics (LPO) interoperability demo with the Arista 800G switch.
    • Connection 1: LPO to LPO
    • Connection 2: LPO to DSP
    • Connection 3: DSP to DSP
  • G800GE-02 OSFP800 & QSFP-DD800 800GE BERT, FEC, L2 Test System will be shown in an Electrical BERT interoperability test using 106.25Gb/s electrical lane signaling rates.

Speak to a Keysight Expert at OFC
Booth #3701

At OFC, meet a Keysight expert to discuss your test and measurement issues, or get your questions answered. Tell us what you would like to discuss, and we will find an expert for you.

Book a time

Short Courses and Papers at OFC by Keysight
Booth #3701

Monday, March 25

8:30 a.m. – 12:30 p.m.
Room: TBD
PSC369: Hands-on: Test and Measurement for Coherent Optical Transceivers

Tuesday, March 26

5:30 p.m. – 6:00 p.m.
Room: 6C
High Capacity and High Spectral Efficiency Transmission for 1.6 Tb/s and Beyond

Keysight Optical Offerings

Click Keysight’s Optical Solutions for more information

Have questions or need help?

Contact Us