Choose a country or area to see content specific to your location
-
PRODUCTS AND SERVICES
-
Oscilloscopes
-
Analyzers
- Spectrum Analyzers (Signal Analyzers)
- Network Analyzers
- Logic Analyzers
- Protocol Analyzers and Exercisers
- Bit Error Ratio Testers
- Noise Figure Analyzers and Noise Sources
- High-Speed Digitizers and Multichannel DAQ Solutions
- AC Power Analyzers
- DC Power Analyzers
- Materials Test Equipment
- Device Current Waveform Analyzers
- Parameter / Device Analyzers and Curve Tracers
-
Meters
-
Generators, Sources, and Power Supplies
-
Software
-
Wireless
-
Modular Instruments
-
Network Test and Security
-
Network Visibility
-
Services
- KeysightCare Service and Support
- KeysightAccess Service
- Calibration Services | Global Calibration Services
- Repair Services
- Technology Refresh Services
- Test as a Service — TaaS
- Network / Security Services
- Consulting Services
- Financial Services
- Education Services
- Keysight Support Portal
- Used Equipment
- All Services
-
Additional Products
- All Products, Software, Services
-
-
Solutions
-
Explore by Use Case
Explore by Industry
- All Solutions
- Learn
- Support
What are you looking for?
mmWave Material Measurement
Advancing electronic materials for the 5G era

Characterizing 5G and mmWave Materials

Signal losses are a major concern for the 5G ecosystem, particularly in the millimeter-wave freqency band. Important characteristics such as low dielectric constant (Dk) and low dissipation factor (Df) are required to enable a lower latency signal to avoid signal loss at high speed.
For a typical low loss (0.0001<Df <0.01 typical) thin film material, we recommend using the split cylinder cavity resonator (SCCR) fixture, which simply place the material under test in between the fixture holders, then tighten it with the lever on the side. Users face challenges to use the right sample thickness corresponds to the different frequency points, to obtain the maximum accuracy.
Application Note
.png)
Characterize from low frequency to mmWave range
Measure confidently with broad range of fixtures
Group-of-Expert.jpg.png)
Determine the right methods for each unique material
Tap Keysight experts experience and insights to customize your solutions
Wide-Dynamic-Range.png)
Automate complex permittivity and permeability measurement
Configure dielectrics measurement setups through software
Keysight mmWave Material Measurement Solutions
Our dedicated material measurement software and fixtures, and industry-leading performance network analyzers enable accurate and repeatable low-loss materials measurements within the millimeter-wave frequency range.
Additional Resources
Want help or have questions?
- © Keysight Technologies 2000–2023
- Privacy
- Sitemap
- Terms
- Trademark Acknowledgements
- Feedback