System Requirements

  • A Pentium PC with Windows NT 4.0.1 Note: Windows NT 4.0 MUST have Service Pack 3 or later installed. To check the version on your PC look on the Task bar under Start, Programs, Administrative Tools, Windows NT Diagnostics.
  • If you want to make actual measurements, you'll also need a GPIB card for your PC and maybe a VXI card depending on what hardware you're using. If you are using Keysight I/O Libraries you will need version G.02.01 or later (available below).

Note: You can run the software in the default "Demo" mode and make simulated measurements without any instruments or I/O hardware.

1Pentium is a U.S. registered trademark of Intel Corporation.

Windows NT is a U.S. registered trademark of Microsoft Corporation.

Interface Upgrade for Keysight I/O Libraries

If you want to use the VXI-11 interface of the Keysight E5500A SCPI Remote Interface you'll need this. It adds an interface of type "Internal Instrument" to the Config Utility of Keysight I/O Libraries.

This download (file) is a self extracting archive. Save it in an empty directory on your PC and then execute it to extract the archive. You must already have the Keysight I/O Libraries software installed on your PC. Execute the file install.exe (extracted from the archive) to install these files. Then run the I/O Config utility and configure an Internal Instrument interface.

segue.exe PC Format (DOS), 275KB, 1998

G.02.01 hpiolibs.exe PC Format (DOS), 8.0MB, 1998

Keysight는 가능한 최신 버전을 사용하는 것을 권장하며, 최신 버전에는 현재 사용 가능한 가장 최신 버그 수정 및 보안 패치가 포함되어 있습니다.
릴리스 날짜 버젼 버전 설명
2004-02-20 n/a N/A
릴리스 날짜 버젼
2004-02-20 n/a
Version Description
N/A

다운로드 방법

  • See Above

설치 방법

  • See Above

라이센스

  • Does Not Require a License

Installs on: PC

운영 체제

  • Windows NT

선결 조건

  • See Above

지원되는 계측기

  • E5500A
사용 가능한 소프트웨어 버전이 없습니다.
SHOW MORE