Confirm Your Country or Area
Confirm your country to access relevant pricing, special offers, events, and contact information.
Products + Services
Oscilloscopes + Analyzers
- Spectrum Analyzers (Signal Analyzers)
- Network Analyzers
- Logic Analyzers
- Protocol Analyzers and Exercisers
- Bit Error Ratio Testers
- Noise Figure Analyzers and Noise Sources
- High-Speed Digitizers and Multichannel Data Acquisition Solutions
- AC Power Analyzers
- DC Power Analyzers
- Materials Test Equipment
- Device Current Waveform Analyzers
- Parameter and Device Analyzers, Curve Tracers
- Generators, Sources + Power
- Modular Instruments
- Network Test
- Network Security + Visibility
- Additional Products
- KeysightCare Service and Support
- KeysightAccess Service
- Calibration Services
- Repair Services
- Technology Refresh Services
- Test as a Service (TaaS)
- Test Asset Management and Optimization
- Network/Security Services
- Consulting Services
- Financial Services
- Education Services
- Keysight Support Portal
- Used Equipment
- All Services
- All Products, Software, Services
- Oscilloscopes + Analyzers
Trigger and clock signal auto-synchronization bus.
The autosynchronous bus (AS bus) bridges are used to synchronize multiple digitizer modules together, taking care of the distribution of all necessary trigger and clock signals.
Synchronous digitizing improves the accuracy of cross-channel measurements and is essential for accurate time correlation. The AS bus system can be used to phase-synchronize all digitizers to an external standard (such as a 10 MHz reference) or to improve trigger flexibility by allowing any trigger input (channel or external trigger input) to be used as the trigger source for all the other digitizers in the system. The AS bus circuit allows selected clock and trigger signals to propagate through all the connected modules. The position of each card is automatically detected, enabling the system to calibrate the individual channel timing delays, so that all the connected ADCs are clocked at the same time.
A simple software function allows the combination of the digitizers so that they appear as a single instrument with many channels.