Here’s the page we think you wanted. See search results instead:

 

Contact an Expert

E2614A 0.5 mm Wedge Probe Adapter for TQFP and PQFP, 8 Signal, qty 1

Sold By:

Starting From US$ 252

Typical Configuration  

Typical Configuration

E2614A Wedge probe adapter, 0.5 mm, 8 signal

Configure

Prices for: United States

* Prices are subject to change without notice. Prices shown are Manufacturer's Suggested Retail Prices (MSRP). Prices shown are exclusive of taxes.

Key Features & Specifications

  • Easy connection to surface mount ICs
  • Safe, with no chance of shorting
  • Mechanically non-invasive contact
  • Operating voltage: less than 40 V (dc + peak ac)
  • Operating current: 0.5 A maximum
  • Capacitance between contacts: 2 pF (typical)
  • Self-inductance: 15 nH (typical)
  • Contact resistance: less than 0.1 Ohm

Description

The Keysight E2614A is a wedge probe adapter for thin quad flat pack (TQFP) or plastic quad flat pack (PQFP). If you've ever tried to probe a surface mount component, you've probably experienced one or more of the following frustrating situations: accidentally shorting IC pins together; electrical and/or mechanical problems with soldering small wires onto leads; and/or holding multiple probes and trying to use your scope at the same time. The Keysight Wedge Probe Adapter provides a solution to these frustrations.

It is easy to insert and stays put - no need to solder small wires onto leads. The Wedge is mechanically non-invasive, so you won't damage the legs of the IC. It makes two contact points with each leg of the IC. This redundant physical connection increases the electrical reliability of the connection.

  • Easy connection to surface mount ICs
  • Safe, with no chance of shorting
  • Mechanically non-invasive contact
  • Operating voltage: less than 40 V (dc + peak ac)
  • Operating current: 0.5 A maximum
  • Capacitance between contacts: 2 pF (typical)
  • Self-inductance: 15 nH (typical)
  • Contact resistance: less than 0.1 Ohm