RF & Microwave Test Accessories

• EM SPDT, Bypass, matrix, transfer and multiports switches
• DC up to 67 GHz
• 0.03 dB insertion loss repeatability
• Excellent isolation and low insertion loss

• FET and PIN solid state switches
• 300 kHz to 50 GHz
• Ultra fast switching and settling time
• Excellent isolation

DC to 26.5 GHz PXI hybrid switch modules route RF and microwave signals in automated test applications. It provides superior 0.03 dB IL repeatability throughout the operating life with high isolation

• Mixers and frequency extension modules
• Many waveguide bands from 18 GHz to 1.1 THz
• Low conversion loss for excellent sensitivity

• Metrology grade, instrument grade and general purpose grade adapters
• Frequency up to 110 GHz
• SMA, type-N, BNC, APC-7 and 3.5/2.92/2.4/1.85/1.0 mm adapters
• Low insertion loss and high return loss

Drivers, driver & distribution cards, cables...

• Pre-amplifiers and system amplifiers
• 9 kHz to 50 GHz
• High gain and flatness
• Low noise figure

• Fixed attenuators
• DC up to 67 GHz
• 3, 6, 10, 20, 30, 40, 50 and 60 dB
• Signal conditioning and level control applications

• Programmable and manual attenuators
• DC up to 50 GHz
• 0.03 dB insertion loss repeatability per section
• Up to 121 dB attenuation with 1, 5 and 10 dB steps

• DC blocks
• 50 to 67 GHz
• DC voltage rating up to 50 V
• Good return loss

• Planar-doped barrier detectors, low-barrier Schottky diode detectors, broadband directional detector
• 100 kHz to 50 GHz
• Flat frequency response with excellent square law response
• Accurate leveling and power sensing

• Coaxial single- and dual-port directional couplers, hybrid couplers, RF bridges...
• 300 kHz up to 50 GHz
• Excellent directivity
• Flat coupling factor

• Power dividers and power splitters
• DC to 50 GHz
• Excellent amplitude and phase tracking
• Low SWR

• Power limiters
• DC to 50 GHz
• High power protections from ESD and RF power
• Exceptional return loss

• Active single-ended and differential probes
• 5 Hz to 12 GHz
• Compatible with Keysight's network, spectrum and signal source analyzers
• Provides high impedance probing

Direct-reading frequency meter, 3.7 to 12.5 GHz...

• Terminations (loads, opens and shorts)
• Frequency up to 50 GHz
• Calibration standards and general purpose
• High return loss

• Waveguide accessories

Broadband high power bias networks to 50 GHz...

Cable assemblies (Type N and 3.5 mm) & microwave bead assemblies...

• Comb generators
• Frequency up to 67 GHz
• Excellent phase and amplitude tracking
• Phase calibration and chracterization of non-linear devices

• Equip your FieldFox handheld analyzer with quality accessories
• Cables, adapters, calibration kits, antennas, RF and microwave accessories and other general purpose FieldFox accessories