Last updated: 27-September-2011

- Version: 7.04.006
- Build: 7.4.37.06
- FPGA Versions: 
  - Exerciser_X16          : 4.7
  - PTC                    : 4.50
- Firmware version         : Version 2.7 
- Condor PLD version       : Version 1.0
- Platform Version         : 1.10.1004
- Package GUID             : 5550AECD-3269-4A46-9275-B2B4039DED18
- AgtUSBManager            : Version 3.7
- Update GUI               : Version 3.0
_______________________________________________________________________________

ENHANCEMENTS:
  - Windows 7 (32-bit, 64-bit) support

IMPORTANT USAGE NOTES:
1. Please ensure the USB Device(s) is unplugged during Installation
2. If you have USB Device(s) (E2960B) attached to your system but only one or none of them  
   receives a valid module number (module numbers on the E2960B devices are 10001, 10002 
   etc.),  this might be due to one of the following reasons:
   a. The USB Device(s) has been plugged in for the first time after rebooting the host controller 
      PC and another USB Device or module was already locked by a session. Please close all 
      existing sessions and update the module numbers. Now run Start->Programs->Agilent SPT-
      >Tools->Diagnostics and hit the button 'Update Module Numbers'. 
   b. If you are working on a system with Windows XP SP2 this might be a problem with the 
      loopback addresses. This has been fixed by Microsoft in the patch KB893066. You can 
      download the patch at the Microsoft site http://www.microsoft.com/downloads/
3. If your USB controller supports USB2.0 make sure that you use the delivered (or corresponding) 
   USB2.0 cable only.
4. Release 7.x(E2960B Gen2 Exerciser) & Release 8.x (U4305A Gen3 Exerciser) cannot exist on 
   same machine.
5. If you don't see modules after updating Firmware then restart AgtN2XUSBManagerService & 
   AgtN2XResourceManager.

KNOWN ISSUES:
SAD00381210  Skew error insertion has no effect on Trasmitted Lanes data 

_______________________________________________________________________________